Jump to content

will_15

Members
  • Posts

    55
  • Joined

  • Last visited

will_15's Achievements

Certified R Fan

Certified R Fan (4/9)

0

Reputation

  1. Looking at the ride height once done it would appear the dealer very kindly left all 4 transports blocks in too. That's not going to end well!
  2. Currently wearing it's winter coat of Wiltshires' finest mud:
  3. One week of normal driving for me (with the exhaust mod) =
  4. Come on, you have to at least try them unplugged! Mine won't be get plugged back in as long as I own the car!
  5. With both the exhausts and the sound actuator unplugged mine stays in normal mode 80% of the time when tooling around London, then race mode for when I fancy it. Sounds epic (once the exhausts are fully warmed up) all the way through the rev range, especially throaty at low revs 1.5-2.5k. Massive extra plus point is I don't have to listen to the noise of the exhaust flaps constantly opening and closing driving in traffic/around residential streets at slower speeds. It was a noisy metallic clicking noise, very obvious with the windows down. Car is perfect now!
  6. I live in London so the R is out on the street along with everyone else. My street, and nearby streets contain everything from numerous battered old sheds and mincabs to a couple of 911s, some M3s, Range Rovers, a new DBS and an RS4. Everyone just gets on with it and you quite quickly work out which neighbours can't park and which areas of the street/side streets tend to be a lower risk for bumper scrapes.
  7. How do the valves unclip? I've seen a pic in the 'flaps thread' and tried some gentle tugging but there not moving. How exactly are they unclipped and do you need a screwdriver or anything to prise them apart and do the grey plastic clip things have anything to do with it? Thanks. No tools required at all. If you look at the offside connection, you will see a small white tab on the top. Pull this towards the rear of the vehicle ( may need to use your nail, can be fiddly). Then simply pull the plug off. The nearside is a little more fiddly, and you wont be able to see the white tab. It pulls towards the nearside of the car. I've seen it suggested that you use a mirror so you can see, but i just did it by feel! Sorry i don't have any photos to work off! Edit - Do the offside first for experience as it will make the nearside a lot easier! Funnily enough I did the nearside in approx 30 seconds, and after 30 mins of trying, I still can't get enough access and leverage on the plug tab on the offside one to get the bugger off. I can clearly see it taunting me when looking above the exhausts. Need a long tool with a hook end I can reach through from the back to hook it with or something.
  8. HOW TO UNPLUG THE SOUND ACTUATOR: 1. Pull the bit of trim off the right hand side of top engine bay area (big arrow). Remove the right hand and middle clips that are now revealed (little arrows) they pull out easily, take care not too drop them. 2. Pop the plastic cover/trim off. Easily done with a bit of levering, pull down and away from the base of the windscreen. The arrow is pointing at the location of the sound actuator - just out of view. 3. You will be presented with the sound actuator itself, simply unplug the wiring using the grey tab on the plug, and as you can see I have stuck some tape on and jammed it back in place to keep dust/dirt out of everything. Not the prettiest solution, but practical. Then repeat in reverse to put everything back in place. This takes less than 5 minutes and I urge everyone to try it once, it's easily reversed and the 'organic' sound is so much better.
  9. That's the one - which is also the same spec of the demo Lookers Battersea had in 6 months ago (not 100% sure if it's the same car though)
  10. It's not me you spotted, but I live in SW11 and a Lapiz blue recently arrived on my street too. I've also seen a black 5dr around, could be the same one as you.
  11. Just lift the bonnet, pop off the right hand bit of trim up by the wipers, unplug the grey plug right in the centre of the bottom of the windscreen which goes into the half visible round speaker type device and hey presto - done. I googled and found a guide, it's a really simple job.
  12. Unplugged my soundaktor this evening after 2000 miles of not being sure if I liked the 'fake' noise and WOW, sounds so much better!! Can hear all the exhaust noise, pops etc in race mode (normally quite hard with a manual), no tinny/metallic sounds and sounds so much more refined and 'organic' under WOT. Even if you like the soundaktor noise, at least give it a go unplugged, worth experimenting for a 2 minute job!
  13. Is the clonk from the front? Could be same as mine - halfway down here viewtopic.php?f=39&t=6443&start=30
  14. Earlier in the thread I said I was having a similar problem to the OP, finally got round to checking it out with a wheel off on a jack, lo and behold a shipping block still in situ. Great job on the PDI then... Will be booking it in my local (not supplying) dealer this week to replace the damaged sleeve and whatever else they find. Ride is so much better now!
×
×
  • Create New...