Jump to content

Chippy_boy

New Members
  • Posts

    18
  • Joined

  • Last visited

Everything posted by Chippy_boy

  1. I searched for this thread since I am a VW Golf R (7.5) owner with Mountune Stage1 remap. To my enormous surprise and disappointment, the car (5 years old) just failed its first MOT with the map installed. Failed with emissions being out of spec, and far too high CO output. No idea of the cause - could have been lambda sensor or airflow meter or antiknock sensor etc. But I did wonder if it could be the remap that did it, so I flashed the ECU back to stock, retested, and it passed, so obviously it was down to the map. I was not best chuffed tbh. In fairness, Mountune have been responsive and helpful, issuing a new map and saying "this one will pass". But it begs the question why the original didn't. Has anyone else had an MOT failure after a remap - Mountune or any other one? Is this common?
  2. Doesn't surprise me at all that the remap lowers the oil temp. To be clear though @sibbers I only see this when cruising on the motorway. In normal driving, oil temp is around the 100c mark, as it was previously. But cruise along at a constant 75 for half an hour and it drops to high 80's/low 90's. It never did that before.
  3. TBH I don't find it at all strange that an ECU tune could affect oil temps. For example, (prior to the tune) if I drove for quite a long time in D and the oil temp was stable at maybe 103 or so, I noticed that if I switched to S but kept driving in the same gear at the same speed, the temp would quickly drop down to maybe 96 or 97. So clearly something changes to reduce the oil temp. I had imagined it was perhaps increasing the water flow to get more heat out of the radiator perhaps in order to accommodate more engine heat if you are driving aggressively. But I really have no idea. All I know is that temps do drop in S mode compared to D mode.
  4. To be fair, none of that would apply. The OP in that thread had issues because the rolling circumference of the front and back were significantly different. With what I was suggesting, they are not and the Haldex would be oblivious to the fact you had different tyre sizes. 275/30R19 has a circumference of 2034mm. 235/35R19 has a circumference of 2033mm. That's a 0.05% difference, i.e. much less than differences due to normal tyre wear, which the Haldex manages just fine. So there should be no Haldex issues. The only issues are (a) will they fit and (b) will the handling be compromised, i.e. more understeer.
  5. True. And I'd never buy one of those either!
  6. I'll buy one in a heartbeat if they've put some more buttons on the controls. Love my 7.5 and I would have bought an 8 but having borrowed a few of them as loan cars from the garage, I could not get on with the tech at all.
  7. If so, I have a quick question... After a stage 1 Mountune remap a couple of weeks back, I am now noticing that my oil temps on long runs are strangely low - like 86C to 90C. Whereas previously they were the more usual 98C to 106C depending on how hard the car was driven. Oddly, when pottering around town with the Mountune map, the temps are around 100C. But as soon as I go on a long journey at constant revs, the temps start to drop, all the way down to high 80's. Has anyone else seen this? Do you think it's anything to be concerned about? I think oil temp of 80C and above is probably OK in terms of engine wear etc, but it seems low. Thanks
  8. TBH I am not really paying much attention to the water temp. I just mentioned that in passing. And having tested the heater somewhat more, it's working fine. I must just have been feeling cold that day. The only issue is the oil temp. I've read elsewhere that sometimes race-tuned engines (generally, not VW specific) sometimes have issues in normal driving because they don't run hot enough. So I do wonder if Mountune have changed the cooling profile in order to keep temps down when racing. Anyway, good shout about a new thread. I will create one. Thanks
  9. Funny thing is, i also noticed on the long motorway trips that I was freezing cold... something I have never noticed before. I had to crank the temp up to 25 to get any warm air in the cabin. But that really makes no sense at all because the water temp was a solid 90 all the time, and the AC's heat comes from the water. So maybe it was just my imagination, but I don't ever remember being cold when driving at the temp set to the normal 21C.
  10. Depends what your goal is 😉 Mine was not to change the appearance, it was to get more rubber on the road 🙂 I don't buy the idea that this would be bad for the haldex, since the rolling diameters are close enough to be irrelevant - like normal tyre wear with 4 identical wheels/tyres could introduce variances as large as this. But the point about most of the traction being at the front is a valid one, so I am not sure fatter tyres at the back would make the car go faster, but it might make it brake faster.
  11. And old thread but deserves an update... My 2019 7.5 R always had the oil between 97 and 106 when warmed up, and those were extremes. Most of the time, between 98 and 103. However, I've recently installed a Mountune remap and noticed something weird. Pootling around, temp soon stabilized at around 100 - perfectly normal and just as I would expect. But here's the thing... I just drove down the motorway at a reasonably constant 75 mph in 7th, and then I happened to look at the oil temp, and it had dropped to 86!??!! It never did this before. And it wasn't a one-off. I tested it on the 1 hour drive home and it did the exact same thing. About 100 getting on the motorway, dropped to 87C after about 30 mins of driving. Is this something to be concerned about? Maybe Mountune have changed the oil pressure/flow to try to limit temps during spirited driving? But is 86C too low?
  12. Will it though? I would get that it is bad for the haldex if the rolliing diameters are different, but in this case they are not. Surely when driving around and not skidding all over the place, the haldex won't be able to tell the difference and will be quite happy. And on a track - not that I plan on doing much in the way of track days - it would just mean you'd be less inclined to oversteer. I can't imagine how it would do any harm to the haldex. More of a concern is will they fit I think.. and the cost. But aesthetically - an important consideration for me - I think it would like really cool!
  13. I don't know if this is a bonkers idea but looking at a new set of wheels for my R, I was wondering whether I could try a 19x9.5 wheel with 275/30's on the rear? Obviously this won't fit on the fronts without rubbing, and/or sticking out beyond the wheel arches and being an MOT fail. But I could stick with the 235/35's on the front, and maybe get away with 275/30's on the rear. The rolling diameter is nigh on identical - like 0.5mm difference so no problem with the Haldex. But would they fit? If I got the wheels with an ET50 offset, they would stick out 19mm more, so probably too much. But something like ET55 would mean poking out only 14mm more and they'd go inside the wheel arch by about 1 inch more. Is there room between the wheel and the suspension for that? Has anyone tried this?
  14. Hello folks! Sorry for the late reply - completely missed these - but thanks for your welcoming comments. Here's a quick pic of the old girl. I'm not really into modding it - I've got a pair of S2T paddles arriving soon and that's about it. And I think I will put some winter wheels and tyres on it - can't make my mind up what, but leaning towards Neuspeed. Although the Bola forged FP2 wheels are very tempting, but £2.5k plus another £1k on tyres is a bit steep. BTW the Mountune stage 1 is great... but I don't like their DSG map at all, and I reinstalled stock. It made it whiny in normal driving - holding on to the gears too long and also, very lumpy shifts. When pushing on its fine, but for pootling around town, it was annoying.
  15. Yeah, it's the holding the clutch slipping at high revs which feels SOOOOOO wrong!
  16. Add me as a launch virgin! Not tried it once and I've had my 7.5 R from new for 4 years now. Wimp, I know!
  17. Morning all. Starting out on my Mk 7.5 upgrade journey with a Mountune Stage 1 ECU and TCU remap today. So thinking about upgrading the brakes as well. Is there any benefit in swapping the OE disks and pads for same size from e.g. Brembo? Or do I need to go for a BBK to make it worthwhile. I won't be doing any track days, this is just for er, "spirited" on road driving. My current front rotors already have a bit of a lip on them (and a strange circular groove running around the left one) so I am happy to replace them. Sticking with the standard size rotors, calipers etc is obviously cheaper and no impact upon insurance costs, but is it worth it? What's your thoughts.
  18. Hello everyone! Enthusiastic Golf R owner here. I've had my beloved Mk 7.5 R from new since late 2019 and finally getting around to upgrading it, starting with an Mountune stage 1 remap which I am installing today 🙂 Looking forward to hearing some helpful advice and tips Cheers Ron
×
×
  • Create New...