Jump to content

agedog

New Members
  • Posts

    16
  • Joined

  • Last visited

Personal Information

  • Name
    Lee

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

agedog's Achievements

Member

Member (2/9)

4

Reputation

  1. Hi Beno it’s the sensor at top left of the engine, camshaft one. The magnetics in them worsen and throws the positioning sensor out causing fault codes. Easy to change. (Defo didn’t remove the exhaust manifold!) good luck. Make sure you change oil and check plugs.
  2. Yes I changed camshaft sensor too just in case! Bit fiddly but not too hard....
  3. I’ll be completely honest these cars are ragged around under lease contracts and then purchased by unsuspecting owners thinking it’s only 3 years old what can be wrong.!!? Well biggest issue is that they aren’t serviced AT ALL! They have stamps in the books but oil changes never been done! After that rant, the above was the main issue with mine! I taught myself how to service the engine, Haldex and dsg box that way I knew they had been done and Done properly. the rough idle 9 times out of 10 on these Engines will be poor oil condition or lack of servicing, plus maybe spark plugs. The rough idle was fixed with a home oil change and I replaced the spark plugs, in my case it was with RS7 plugs, but I have to admit when I changed the plugs the standard plugs were loose/hand tight at best!!! Not good!!! honestly bought my 2015 R and after 2 weeks massively regretted it as it clearly hadn’t been looked after, BUT, I did everything myself, every oils/filter/service etc, after I did this the car was a dream! good luck. Ps make sure you Take the pump off and clean the haldex filter!... non serviceable item my arse! another tip 2014/15/16 R’s get the haldex software updated.
  4. Yes - I think thats the next job. Although never changed a DSG box oil before, looks like a pain in the rear with bottom drain and bottom fill!! Whats the Haldex, like assume thats bottom fill also??
  5. Cheers for advice - I too shall be doing oil change on drive every 6mths.
  6. Hi All, Bought my 2015 G7R back in Dec and the service book said it was serviced in Mar 2018 @ 53k mile by Arnold Clarke VW, Bathgate, West Lothian ... Anyway its now March and done 58k mile and the oil and inspection light came on. (They have obviously set it to a annual service/inspection programme, which is wrong as its a condition based service car!) So long story short, I decided to do my own oil/filter service on my drive earlier today, for peace of mind knowing its done (and done properly!) .... Take a look at the oil and filter that a apparently "5k miles" old!! 😩 That oil and filter looks much older than 5k miles doesnt it????? The pollen filter had clearly never been changed, and the air filter looked older than 5k miles too!!! My worry is that on the dealers 53k mile service they apparently also did the haldex and dsg oil!!?? Im guessing they skipped that too!... Oh I also put some new RS7 spark plugs in, however when removing the OEM plugs (also apparently 5k miles old) found all 4 of them to be hand tight! Obviously never torqued them up!!! I am feeling good that the oil is done, but have a feeling the constant crappy oil has caused the "A camshaft position, over advanced" intermittent errors I am getting by clogging up some solenoids or the like... I will continue to tinker on!...
  7. Hi all, I know this has been brought up before, but wanted to open this issue up again and give some thoughts to this problem; as I am in fact having issue since I picked up my 2015 7R in Dec, and it would seem no one has ever seemed to end a thread with any certain conclusion! Approx 50% of the time the idle on my 7R is unbearably rough, no rhyme or rhythm to it; could be hot or cold engine, AC/Heat seat etc on or off, no matter. I had the car in at the stealers the other day regarding a heated seat problem (separate story!) and they had a list of error codes that took a quick picture of from out on my file. (see attached) I asked them ref the errors to which they advised no need to worry unless I am experiencing a problem!!! Anyway today rough idle was really bad and actually stalled at one point, and I thought i'd do some digging myself. Here are my conclusions which I would like some thoughts on if poss? Error 1: Code P001100 A Camshaft Position (Bank1) Timing over Advanced or System Performace Potential Fixes: 1. Bad wiring to the camshaft oil control valve (bank1) intake camshaft 2. Need replacement camshaft oil control valve 3. Need to check timing alignment for timing probs. Error 2: Code P034100 Camshaft Position Sensor Circ. Range/Performance Potential Fixes: 1. Replace faulty camshaft sensor (anyone know how to do this? is it easy on the 7R?) 2. Connections to the sensor are corroded/faulty. Anyone got any thoughts on this, are the two faults connected? Would Error 1 disappear if I replaced camshaft sensor for Error 2? Its all a bit uncertain! It would make sense that these errors/items would cause lumpy idling, and infact today did notice some signifcant delay in gear changing... Hopefully this post could help others who are experiencing the same. Cheers. PS: Other issues with car since bought in Dec 18: 1. Alternator Died (£550) 2. Heated seat pad ((£450) 3. Constant ACC issue/dash light goes away after switching car off and on (Undiagnosed - but found error B10E7F0). Not my best experience of VW ownership! 😡
  8. Hi All. The bottom (arse warmer) section of drivers side leather seat heater doesn't heat up on my 15 plate 7R; but the back/lumber section of the seat works fine. Has anyone else come across this problem on any other thread? Are they separately fused (back/bottom heater) or am I looking at element burned out/broke? Could be a loose connection but cannot see look under seat. I have it booked into stealer early feb but worried thwy will just say its worst case. Any help much appreciated. Cheers
  9. Yep I'm being an idiot... 🤣 Its because in my last car (Audi) I just released the brake and it would start-up and roll. Thanks a lot for info.
  10. Hi All, when the engine cuts out at lights etc from stop/start on my 7R DSG (rush hour driving honest!), if auto hold is on it doesnt automatically start again when I release the footbrake. Only seems to restart if i press the auto hold button off... Am I missing something obvious here or do I have a tech prob?
×
×
  • Create New...