Jump to content

Panel Misalignment


Pigpen

Recommended Posts

Have been unwell prior and after collecting the R - probably all the excitement  :grin:

 

Anyways as the weather has been totally sh*te I have decided to leave the R tucked up in the garage and continued to use the pot hole crusher.  But tonight when I parked up I noticed the alignment of the rear bumper with the adjacent panel was flush one side but recessed by 3-5mm on the other.  Is this normal / acceptable within VW standards or should I make an issue about it?  Is it easy to correct or likely to cause more damage being corrected so just ignore it?

 

Appreciate any advice.

Link to comment
Share on other sites

The gap between the tailgate and glass is approx 4mm bigger on the left side compared to the right on my car, VW don't seem to have any standards whatsoever... My supplying dealer fobbed me off saying they don't have a VW approved body shop, I've complained to VWCS whom recomended a couple of local dealers with body shops; these two dealers have some rubbish reviews online hence I haven't followed it up yet.

Link to comment
Share on other sites

Have been unwell prior and after collecting the R - probably all the excitement  :grin:

 

Anyways as the weather has been totally sh*te I have decided to leave the R tucked up in the garage and continued to use the pot hole crusher.  But tonight when I parked up I noticed the alignment of the rear bumper with the adjacent panel was flush one side but recessed by 3-5mm on the other.  Is this normal / acceptable within VW standards or should I make an issue about it?  Is it easy to correct or likely to cause more damage being corrected so just ignore it?

 

Appreciate any advice.

 

Sorry to hear you have not been well. In fact, when I collected my R, I was also pretty unwell and found it really difficult to take in all the information during the handover which I must admit was superb. The car had been prepared immaculately and is as faultless as a mass production car can be.

 

Regarding your rear bumper and rear quarter panel fit, they should be absolutely perfect and flush on both sides with no difference. Mine is perfectly aligned: I've just checked. A 3mm-5mm recess is a huge. So, you should take it back to the dealer to get this sorted. Pity you have this issue, especially after such a traumatic and long gestation delivery process for your little Miss Piggy.

Link to comment
Share on other sites

Sorry to hear you have not been well. In fact, when I collected my R, I was also pretty unwell and found it really difficult to take in all the information during the handover which I must admit was superb. The car had been prepared immaculately and is as faultless as a mass production car can be.

 

Regarding your rear bumper and rear quarter panel fit, they should be absolutely perfect and flush on both sides with no difference. Mine is perfectly aligned: I've just checked. A 3mm-5mm recess is a huge. So, you should take it back to the dealer to get this sorted. Pity you have this issue, especially after such a traumatic and long gestation delivery process for your little Miss Piggy.

Its not the recess that is 3-5mm wide that is the difference between the panels so instead of being flush one sticks proud of the other 3-5mm.  My dealer said they would look at it but it's 100 mile round trip  :undecided:

Link to comment
Share on other sites

Its not the recess that is 3-5mm wide that is the difference between the panels so instead of being flush one sticks proud of the other 3-5mm.  My dealer said they would look at it but it's 100 mile round trip  :undecided:

 

I did understand exactly what you meant. There should not be this difference. They should be flush with each other and no difference either side.The bumper needs to be re-aligned or it could be warped. Hope it is not the latter as I had this with my Mk6 GTI. Because if one side is flush and the other is not, then you have a problem. PITA.

 

I must admit when comparing overall fit and finish to the S3, the R is the poor relation, no doubt.

Link to comment
Share on other sites

Just worried they might do more damage!

 

Why don't you go to a VW Approved Bodyshop or VW Dealer closer to your home. The Warranty work can be carried out by any VW Dealer or  VW Approved Bodyshop. It is not a prerequisite that only the supplying dealer needs to complete Warranty work.

Link to comment
Share on other sites

This is the SW that is my nearest dealer  :grin: To be fair there is one a little nearer but last time we dealt with them they parked a courtesy car in our flower bed!  We had to get a tractor to pull it out and the repair bill was around £5k.  Do you think I should call them?  Might be worth investigating where their approved body shop is as it may be nearer.

Link to comment
Share on other sites

Sorry to hear you have not been well. In fact, when I collected my R, I was also pretty unwell and found it really difficult to take in all the information during the handover which I must admit was superb. The car had been prepared immaculately and is as faultless as a mass production car can be.

 

Regarding your rear bumper and rear quarter panel fit, they should be absolutely perfect and flush on both sides with no difference. Mine is perfectly aligned: I've just checked. A 3mm-5mm recess is a huge. So, you should take it back to the dealer to get this sorted. Pity you have this issue, especially after such a traumatic and long gestation delivery process for your little Miss Piggy.

 

 

Definitely not acceptable, makes me think it has had a new bumper fitted (badly) following a minor transit bump, or it has taken on a soft bump that didn't leave a mark in the paint. My GTDs rear bumper was perfectly aligned new, and the replacement one following a rear shunt was fitted just as well - tiny gap between the bumper and the rear quarter panel, literally just wide enough to get a piece of thick paper/thin card between.

Link to comment
Share on other sites

The panel fit on both my cars has been spot on - what you describe is definitely not right. Without a photo its hard to tell exactly where you're talking about on the car, but it sounds as though the bumper has been leaned on by another car in transit perhaps. If this is the case, have you tried gently pulling the bumper back? When I had my slight altercation with a pillar in a car park, the rear bumper moved forwards like you describe and sat about 3mm proud of the adjacent panel. When I pulled it back it slipped nicely back into its clip. Worth a go?

Link to comment
Share on other sites

This is the SW that is my nearest dealer  :grin: To be fair there is one a little nearer but last time we dealt with them they parked a courtesy car in our flower bed!  We had to get a tractor to pull it out and the repair bill was around £5k.  Do you think I should call them?  Might be worth investigating where their approved body shop is as it may be nearer.

 

Try the nearest one out. If joy is missing from the visit, then enjoy driving to your supplying Dealer. Hope you get it sorted. Very annoying with these little niggles.

Link to comment
Share on other sites

I'll try and get some photos up.  It doesn't stand out like a sore thumb but something made me check it out.

1mm very max, but not 3-5mm. If you can't move it yourself, take it to your dealer. 100 miles round trip is nothing in a car you like driving. If you can't be bothered at least take it to a local one for an opinion - you don't have to use them.

Link to comment
Share on other sites

On my car the passenger side front door is not quite perfectly aligned. It is a teeny weeny bit out but nothing that really bothers me too much. Saw two other Rs with the same slight misalignment of the front passenger door.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Current Donation Goals

    • Raised £170
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...