Jump to content

Panel Misalignment


Pigpen

Recommended Posts

Ok my supplying dealer is washing their hands of it saying it is warranty work so I can take it wherever I like could be good but anyone else may accuse me of having a knock.  Is this something I should take to the sales or service section of my local dealer as neither are returning my calls and conscious that the latter close at 1pm today.

Link to comment
Share on other sites

Ok my supplying dealer is washing their hands of it saying it is warranty work so I can take it wherever I like could be good but anyone else may accuse me of having a knock. Is this something I should take to the sales or service section of my local dealer as neither are returning my calls and conscious that the latter close at 1pm today.

It's definitely not warranty work, it's an imperfection that unfortunately should have been spotted at pdi or collection. If you take it to any other dealer they're going to simply say it's been knocked whilst in your possession. You're on slightly tricky ground if you don't have a helpful dealer. If the bumper has been leaned on during transit it won't necessarily have left a mark - the cars have foam pads on the bumpers and they're parked inches from each other.

 

If you've visited your dealer in person, had a pleasant confident assertive conversation, putting your position across clearly with the facts in a good humoured but firm way, have exhausted every department there with no success, then you start dropping not very subtle hints that you will of course give them positive feedback to VW and on the various forums that you're on. If that fails then you make it clear that you'll make a complaint to VW. However the point is that you don't do ANY of this until you've had a face to face meeting with your dealer.

Link to comment
Share on other sites

Mr Pigpen:

As has been very eloquently posted by AgentFruit, take your car to your dealer ASAP and get them to sort it. If they wish to play the Warranty Card, then so be it. Get their Warranty Manager to contact VW for sanctioning of the work.

Link to comment
Share on other sites

Have just been out to do a light clean as I asked the dealership not to touch it.  Now it is in the open I can see the inner lining is not secured and there is paint missing at the end of the bumper.  It's not like me to miss that so I am a little perplexed but it does look like it has had a shunt not a hard one.  The paint is extremely thin anyway on the wheel arch and I can see it is black beneath.  Will take some more photos.  Am I still within the time frame to refuse the car and return it?

Link to comment
Share on other sites

Have just been out to do a light clean as I asked the dealership not to touch it. Now it is in the open I can see the inner lining is not secured and there is paint missing at the end of the bumper. It's not like me to miss that so I am a little perplexed but it does look like it has had a shunt not a hard one. The paint is extremely thin anyway on the wheel arch and I can see it is black beneath. Will take some more photos. Am I still within the time frame to refuse the car and return it?

Tbh I think you're on shaky ground as you've taken delivery of the car. This is my point about needing to see the car cleaned at the dealer, regardless of paint swirls. I know you say you've kept it in the garage, but the dealer has no reason to believe this, unless it actually looks like a paint fault.

Link to comment
Share on other sites

Have just been out to do a light clean as I asked the dealership not to touch it.  Now it is in the open I can see the inner lining is not secured and there is paint missing at the end of the bumper.  It's not like me to miss that so I am a little perplexed but it does look like it has had a shunt not a hard one.  The paint is extremely thin anyway on the wheel arch and I can see it is black beneath.  Will take some more photos.  Am I still within the time frame to refuse the car and return it?

 

If you wish to reject the car for this issue, (which you did not point out to the dealer on collection), you are on very shaky ground. Yes, you have a set time frame when you can reject the car but I don't know the time frame. Anyway, you have to first give the dealer the opportunity to try and fix the problem if they accept there is a problem which was there prior to you taking the car away. Now how do you prove that this was the case?

Link to comment
Share on other sites

Fortunately the paint 'chip' is on plastic rather than the metal work.  You could possibly touchin with a pen but there is definitely a fault as the paint is too thin.  They are going to take it back and have a look so hopefully will get sorted.  I'll put a picture up in a minute. 

Link to comment
Share on other sites

DSCF1781.jpg

Very thin paint on the inside of the panel

DSCF1761.jpg

Liner hanging down

DSCF1763.jpg

Missing paint isn't huge but stands out on the white.  When I collected the car it was in a side garage with not much light.  Pretty sure I would have spotted the liner so it must have been pushed into place before I set off and happen on the way home.  All look relatively simple to fix but don't like the thought of paint on a new car so maybe better with a touch up pen?

Link to comment
Share on other sites

I once had a bodywork issue on a 2001 Polo 1.9 TDI. The first wash I gave it following delivery, I noticed a slight press crease along the wheel arch edge, but perfect paintwork. Obviously done at the factory prior to painting and missed at the factory QC checks and dealer PDI. As it wasn't spotted at PDI, the dealership admitted it was a manufacturing fault that they'd missed and so the rectification was at the cost of the dealership. VW take no responsibility for physical manufacturing defect or transit damage once the PDI is signed off.

 

Your supplying dealership will have to sort this if anyone is going to do it at no cost to you.

Link to comment
Share on other sites

I once had a bodywork issue on a 2001 Polo 1.9 TDI. The first wash I gave it following delivery, I noticed a slight press crease along the wheel arch edge, but perfect paintwork. Obviously done at the factory prior to painting and missed at the factory QC checks and dealer PDI. As it wasn't spotted at PDI, the dealership admitted it was a manufacturing fault that they'd missed and so the rectification was at the cost of the dealership. VW take no responsibility for physical manufacturing defect or transit damage once the PDI is signed off.

 

Your supplying dealership will have to sort this if anyone is going to do it at no cost to you.

It will be interesting to hear their comments on the thinness of the paint its pretty poor.

Link to comment
Share on other sites

Perhaps the main reason bumpers are a different shade to the metalwork on most colours?

 

Luckily, mine are a perfect match.

I've only seen one mismatch and that was on a Red Mk7 Golf SE at the dealership and it was on a podium in front of the showroom in full view.

Link to comment
Share on other sites

It will be interesting to hear their comments on the thinness of the paint its pretty poor.

 

Be most interesting. I think they must have hoped you would not notice it.

 

Anyway, because of this thread I had a good look at my car for the first time since I got it.

 

As mentioned earlier, the front passenger door will need a 0.5mm adjustment. I'll attend to this in the next few weeks when time and energy permit.

 

On the inside, there is a slight bagginess on just one side of the grey Alcantara on the passenger seat base. I'll fix this with a steam iron. Time and energy permitting.

 

All-in-all, a pretty well finished car but probably not as good as an Audi.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Current Donation Goals

    • Raised £170
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...