Chris1h Posted July 30, 2017 Report Share Posted July 30, 2017 Have a set of team dynamic 1.2 on the way in gloss anthracite and what should i protect them in? Car is running cadiz atm with gtechniq on. Quote Link to comment Share on other sites More sharing options...
MattM7R Posted July 30, 2017 Report Share Posted July 30, 2017 I've used qtechniq C5 wheel armour on mine and I can't rate it highly enough!! Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Chris1h Posted July 30, 2017 Author Report Share Posted July 30, 2017 4 minutes ago, MattM7R said: I've used qtechniq C5 wheel armour on mine and I can't rate it highly enough!! Sent from my iPhone using Tapatalk 15 or 30ml? not much build up of brake dust? Quote Link to comment Share on other sites More sharing options...
MattM7R Posted July 30, 2017 Report Share Posted July 30, 2017 The 15ml bottle does say on most websites that it will cover wheels up to 17" so I got a 30ml bottle as I wanted to coat the inner rim aswell and there was a small amount left over.Ensure your wheels are spotless and wipe them over with gtechniq panel wipe, coat with C5 then buff off excess with one of there MF1 buff cloths.It's about £45 but it's been on mine since I had the car and it's spot on, brake dust does stick but it literally wipes off when you clean the wheels, even if you neglect it for almost a month! I rate the stuff, it's apparently very high temp resistant aswell so you can do you calipers but mine aren't great, I'm waiting till I get a good spell off work where I can strip them down, re-powder coat and decal then seal before re-fitting. Sent from my iPhone using Tapatalk Chris1h 1 Quote Link to comment Share on other sites More sharing options...
Chris1h Posted July 30, 2017 Author Report Share Posted July 30, 2017 7 minutes ago, MattM7R said: The 15ml bottle does say on most websites that it will cover wheels up to 17" so I got a 30ml bottle as I wanted to coat the inner rim aswell and there was a small amount left over. Ensure your wheels are spotless and wipe them over with gtechniq panel wipe, coat with C5 then buff off excess with one of there MF1 buff cloths. It's about £45 but it's been on mine since I had the car and it's spot on, brake dust does stick but it literally wipes off when you clean the wheels, even if you neglect it for almost a month! I rate the stuff, it's apparently very high temp resistant aswell so you can do you calipers but mine aren't great, I'm waiting till I get a good spell off work where I can strip them down, re-powder coat and decal then seal before re-fitting. Sent from my iPhone using Tapatalk good stuff mate think i will give that a go! MattM7R 1 Quote Link to comment Share on other sites More sharing options...
MattM7R Posted July 30, 2017 Report Share Posted July 30, 2017 This is mine, you can pretty much see how the car looks, that's literally been 2 bucket washed and dried with micro fibre drying towels and then buffed with polishing cloth, car has been coated with gtechniq also, makes it a dream to wash quickly!! I'm sorry I don't have one of the wheels closer up and it's currently p*ssing it down!! Sent from my iPhone using Tapatalk Chris1h 1 Quote Link to comment Share on other sites More sharing options...
Booth11 Posted July 31, 2017 Report Share Posted July 31, 2017 Gtechniq C5 Wheel Armour Gyeon Q2 RIM CarPro DLUX All decent coatings for wheels/wheel arches. mickR 1 Quote Link to comment Share on other sites More sharing options...
Mainframe Posted July 31, 2017 Report Share Posted July 31, 2017 C5 or Rim. 30ml and do two coats with wheeels off. Avoid 'wheel cleaners', wash every week (even if you can't do whole car) with shampoo, and you are good for 1 year plus. Any excess product can be used on exterior plastics (lower windscreen scuttle/wiperetc). To good effect. Chris1h 1 Quote Link to comment Share on other sites More sharing options...
jrw Posted July 31, 2017 Report Share Posted July 31, 2017 I would go for Q2 Rim over C5. Lasts forever. I have done at least 12 wheels inside and out from one 30ml bottle. Haven't been tight with the product either so you would easily get two good coatings on the wheels. Being black, just make sure you buff everything off properly otherwise its a bugger to remove any missed bits as its pretty permanent! You also need to let it cure for at least 24 hours unless you have some fancy Infrared heaters. Chris1h 1 Quote Link to comment Share on other sites More sharing options...
Mainframe Posted July 31, 2017 Report Share Posted July 31, 2017 3 hours ago, jrw said: I would go for Q2 Rim over C5. Lasts forever. I have done at least 12 wheels inside and out from one 30ml bottle. Haven't been tight with the product either so you would easily get two good coatings on the wheels. Being black, just make sure you buff everything off properly otherwise its a bugger to remove any missed bits as its pretty permanent! You also need to let it cure for at least 24 hours unless you have some fancy Infrared heaters. Interesting. I Never used Rim, so cant comment on longevity vs C5. How would you compare the two? (am assuming you have run them) C5 is pretty impressive - more so than Nanloex Ultra Alloy protection, which is only other long term si02 wheel sealant I have used. Quote Link to comment Share on other sites More sharing options...
jrw Posted July 31, 2017 Report Share Posted July 31, 2017 15 minutes ago, Mainframe said: Interesting. I Never used Rim, so cant comment on longevity vs C5. How would you compare the two? (am assuming you have run them) C5 is pretty impressive - more so than Nanloex Ultra Alloy protection, which is only other long term si02 wheel sealant I have used. Looking at the reviews, it is better than C5. I have C5 on my R but i have only done 4k miles in nearly 18 months so it isn't really a good test. But from using it C5 is a lot thinner and doesn't spread as well due to it flashing off so quick. Rim on the other hand is almost oily and has a good 5 min work time and gives you plenty of time to buff off. Because of the oily texture and the long work time it spreads out and a little goes a long way. I have only recently started using it so can't comment on longevity but the wetcoat is also another good product to spray on the rims as a quick fix if you don't want to coat or you want to top up the hydrophobic properties of your sealant. Mainframe 1 Quote Link to comment Share on other sites More sharing options...
Mainframe Posted July 31, 2017 Report Share Posted July 31, 2017 20 minutes ago, jrw said: Looking at the reviews, it is better than C5. I have C5 on my R but i have only done 4k miles in nearly 18 months so it isn't really a good test. But from using it C5 is a lot thinner and doesn't spread as well due to it flashing off so quick. Rim on the other hand is almost oily and has a good 5 min work time and gives you plenty of time to buff off. Because of the oily texture and the long work time it spreads out and a little goes a long way. I have only recently started using it so can't comment on longevity but the wetcoat is also another good product to spray on the rims as a quick fix if you don't want to coat or you want to top up the hydrophobic properties of your sealant. Good response well though out JRW. Interesting about Rim being more oily/slowto flash. I may try some on next car (although I do have an unopened bottle of C5 in my kit to use up). I tend to apply C5 quite thickly - or at least load up the cotton pad well so it goes on liberally. Then work it around. I never found it goes off too fast though if your are working in cool shade. Unlike ExoV2, where you need to sprint..) 4K miles in 18 months? Wow, am guessing you work away (or maybe😉 agoraphobic) Quote Link to comment Share on other sites More sharing options...
jrw Posted July 31, 2017 Report Share Posted July 31, 2017 1 hour ago, Mainframe said: Good response well though out JRW. Interesting about Rim being more oily/slowto flash. I may try some on next car (although I do have an unopened bottle of C5 in my kit to use up). I tend to apply C5 quite thickly - or at least load up the cotton pad well so it goes on liberally. Then work it around. I never found it goes off too fast though if your are working in cool shade. Unlike ExoV2, where you need to sprint..) 4K miles in 18 months? Wow, am guessing you work away (or maybe agoraphobic) Haha, no. I have a company car I do 30k a year in so the R is just a weekend toy for me! Spent 18 months deciding what to get and ended up with the best all rounder and best horse power for the £ Quote Link to comment Share on other sites More sharing options...
ozzyR Posted August 4, 2017 Report Share Posted August 4, 2017 Poorboys wheel sealant is excellent Quote Link to comment Share on other sites More sharing options...
bodas73 Posted August 4, 2017 Report Share Posted August 4, 2017 C5 on my Cadiz still as good as the day they were put on, brake-dust comes off easily Chris1h and MattM7R 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.