Jump to content

Error Workshop !!


Recommended Posts

This is a common error with the parking switch that’s built inside the selector lever so the whole selector has to be replaced and it’s a very involved job to do. Centre console out to get to the interior bolts holding it to the floor, exhaust and centre tunnel heat shield off to remove the selector from under the car and depending on what selector you have already the superseded part may require the a new selector cable.


Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

On 05/02/2019 at 17:08, gpf1xxx said:

My R is with the dealer tomorrow for the warranty DSG shifter replacement. An all day job.  The past few days has seen the 'error' message come on every time I start the car. I will report back on the result of the new parts.

All fixed...dropped car off at 8.15am and it was ready by 2pm. The reassembly of the DSG console has been done perfectly and the car is back to normal.

Link to comment
Share on other sites

  • 1 month later...

My 7R estate flashed up this error message last weekend. It cleared itself after a few seconds but then reappeared the next time I started it. Again, the message cleared itself a short while later. It only appeared if I tried to select M; if I left it in D or S it was completely fine.

 

I took it in yesterday to have it looked at. Apparently it's the F319 switch that's faulty. They're replacing the whole selector assembly today.

 

The courtesy car they've given me is an entry-level Up. It's like driving a shopping trolley. The front of the car is so short that I keep parking it about three feet away from the end of parking spaces.

Link to comment
Share on other sites

  • 1 month later...
  • 3 months later...

I recently purchased a used MK 7 Golf 2.0 TDI with a DSG autobox, within a week I began to get the dreaded message, the fault did not show an the car status nor was it logged on VW Connect app.

the Golf was returned to Inchcape who diagnosed the full shift assembly would need to be replaced under warranty, I hope to have the Golf back tomorrow.

Link to comment
Share on other sites

58 minutes ago, Dunc said:

I recently purchased a used MK 7 Golf 2.0 TDI with a DSG autobox, within a week I began to get the dreaded message, the fault did not show an the car status nor was it logged on VW Connect app.

the Golf was returned to Inchcape who diagnosed the full shift assembly would need to be replaced under warranty, I hope to have the Golf back tomorrow.

Unfortunately this is a common fault.  At least the fix is straight forward and you should be back to happy motoring quickly.

Link to comment
Share on other sites

Hopefully this will not be a reoccurring problem, I have previously had two Golfs and a Sirrocco all with DSG autobox’s and never any problems...fingers crossed
I think it's just a one off issue usually with the mech unit so not the actual gearbox itself just the hardware/software that controls it

Sent from my SM-G950F using Tapatalk

Link to comment
Share on other sites

4 hours ago, SpursMadDave said:

I think it's just a one off issue usually with the mech unit so not the actual gearbox itself just the hardware/software that controls it

 AFAIK this error is usually caused by a faulty sensor in the gear lever assembly, so not in the DSG, nor in the mechatronic unit that controls the DSG.  Obviously there was a batch of sensors that had a high failure rate, VW know about it so they are replacing them without any drama.

 

Replacing the gear lever assembly seems to fix it for pretty well everyone (there is an instruction in the TSB to look at the wiring loom first, but replacing the gear lever is much more common).

Link to comment
Share on other sites



 AFAIK this error is usually caused by a faulty sensor in the gear lever assembly, so not in the DSG, nor in the mechatronic unit that controls the DSG.  Obviously there was a batch of sensors that had a high failure rate, VW know about it so they are replacing them without any drama.
 
Replacing the gear lever assembly seems to fix it for pretty well everyone (there is an instruction in the TSB to look at the wiring loom first, but replacing the gear lever is much more common).


I'm sure I've read of owners having to get their mechatronic unit replaced though may be a different error, luckily not seen it in either of my Rs
Sounds logical as the car is saying put the gearbox in P when it already is so the sensor is fubar

Sent from my SM-G950F using Tapatalk

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Current Donation Goals

    • Raised £170
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...