Jump to content

DazR

Junior Members
  • Posts

    27
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

DazR's Achievements

Member

Member (2/9)

2

Reputation

  1. Great mods you’ve done, could I ask what you used for the front and rear badges? Does the front badge mod affect the radar Thanks Daz
  2. I would deffo buy the D-Plug extension Regards Daz
  3. I’ve heard a lot of people disconnecting or dialling out the start stop feature
  4. I find mine in Race pops on overrun, my previous R was loud with pop and bang map, I don’t miss it to be totally honest
  5. Just wondered why you didn’t like the JB4 as most people think it is very very good..
  6. Nobody else making these D plug extensions?
  7. Thanks, I will try your suggestions
  8. How come I need traction off...? What revs do you suggest starting from, the log needed does it need gradual throttle up to the rev limiter or full attack on the pedal avoiding the kick down switch.. Thanks Daz
  9. Who can advise on best way to get a 3rd gear log, I’m currently using map 4 (7 speed dsg) I go manual mode M3 put throttle right down at 2500 revs and it down shifts to M2, must be doing something wrong Thanks Daz
  10. Rob Just wondered if you have any AFR loom and D-Plug extensions for the 2019 WLTP Golf R currently. Thanks Daz
  11. I’m still amazed that even the garage owners on here have had little if not zero input into what bolts should be changed regardless of VW service manual, also not a single comment about how to do the job from beginning to end, I’m sure people that want to have a tackle themselves would appreciate free advice!
  12. Stephen I’ve just read your comments again, I hope you could clarify something for me, you said that it is not necessary to lower the front subframe although it’s tricky getting the transfer box off. Are you saying that you separated the transfer box from the gearbox which I think would mean removing the driveshafts then axle splines shaft,by removing the Allen bolt deep in the axle spline shaft. Ive not heard this way before so I was interested if this is the case or you managed to get the complete gearbox and transfer box by the front subframe. All the best Daz
  13. Thanks for letting me know your knowledge of TTY bolts, as I have already said I would replace the required bolts if doing this job. So who has done the job of removing and replacing the gearbox, what bolts did you replace out of interest. All the best Daz
×
×
  • Create New...