Jump to content

2015 R 4wd issue


Germanwhippage

Recommended Posts

hi can someone help me with a problem i am having on my r (revo stage 1).

its a 2015 bought it about 6 months ago and long story short bought a really fast GTI instead of an R.

car suffers from severe traction loss like if i am in normal drive and give it more then 30% throttle instant front wheel spin and hopping. doing launch control just results in a lot of wheel hop or just a front wheel burnout. best way to describe the car is its basically like driving a Cupra 300. Having read up on this i changed my haldex pump and oil and i done the pump learn using vcds. still no joy maybe a tiny bit better but no where near what it should be. I dont know what to replace next as there is many things i have  read about on the forums from the culprit being the entire rear unit to just a simple software update or a newer haldex controller. no codes are being thrown as well. if anyone had a similar situation to me and resolved it please tell me as i am just tired of driving around in a stupid quick car and not being able to use it properly. And i really dont want to bring it to my Volkswagen dealership as i have had really bad experiences with them in the past. 

 

p.s when i changed the haldex oil there was quite a large amount of sludge and debris in it and not that much oil came out no where near the 850 ml mark. guessing this was never changed in the car for quite some time.

Link to comment
Share on other sites

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

4 hours ago, Germanwhippage said:

hi can someone help me with a problem i am having on my r (revo stage 1).

its a 2015 bought it about 6 months ago and long story short bought a really fast GTI instead of an R.

car suffers from severe traction loss like if i am in normal drive and give it more then 30% throttle instant front wheel spin and hopping. doing launch control just results in a lot of wheel hop or just a front wheel burnout. best way to describe the car is its basically like driving a Cupra 300. Having read up on this i changed my haldex pump and oil and i done the pump learn using vcds. still no joy maybe a tiny bit better but no where near what it should be. I dont know what to replace next as there is many things i have  read about on the forums from the culprit being the entire rear unit to just a simple software update or a newer haldex controller. no codes are being thrown as well. if anyone had a similar situation to me and resolved it please tell me as i am just tired of driving around in a stupid quick car and not being able to use it properly. And i really dont want to bring it to my Volkswagen dealership as i have had really bad experiences with them in the past. 

 

p.s when i changed the haldex oil there was quite a large amount of sludge and debris in it and not that much oil came out no where near the 850 ml mark. guessing this was never changed in the car for quite some time.


Where are you located?

 

You need to find a specialist VAG tuner as main dealers are just fitters and not technicians/ engineers tbh.

 

Could be a number of issues eg transfer box failure or bevel gears slipping in rear Haldex coupling which sounds a possibility by what you described. The oil is key to keeping it working well as is not over launching the car. It will mean you’ll need a proper tech to diagnose this and normally it’s finding a second hand Haldex assembly as new they are £’s!

 

 

Link to comment
Share on other sites

As you will already know 8 times out of 10 it is a failed pump.

 

But moving on, this post has some good info. No experience of using them but their post is quite informative...

 

What scan tool are using, does it interrogate all the vw control modules esp haldex - 4wd?

 

https://www.haldexrepairs.co.uk/generation-5-haldex-fault-finding-repair-guide/

 

 

Link to comment
Share on other sites

IIRC the rubber donut on the tailshaft can also fail.

 

The best test for the gear slipping on the shaft in the transfer case/bevel box seems to be put the car up on a hoist, select P in the gearbox, and try to rotate the tailshaft using a monster pair of multi-grips.  If it rotates there is usually a problem in the transfer case/bevel box.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...