ChazR Posted August 12, 2021 Report Share Posted August 12, 2021 On 02/08/2021 at 22:06, AddyT said: Hi All, Apologies if this has already been covered. Aside from retrofitting Dynaudio which I think is expensive(?), what are the recommendations for upgrading the speakers? Am open to replacing the spare wheel for a sub like the Dynaudio setup but not essential. Just also interested if people have chosen to upgrade the other speakers in the car, and if so, what to? 😊 Hi mate I went for a full Hertz setup in mine and it sounds awesome. I have a 5 channel Mpower amp powering the 4 front speakers and a 12" Sub in the boot. Much better than Dynaudio now! Cost about £1200 all in obviously you don't have to go that far! A lot of people do the Helix sub install which goes in place of the spare wheel and that is sufficient for most people and costs about £400-600 depending on where you get it from and install it. Quote Link to comment Share on other sites More sharing options...
jtt6 Posted September 13, 2021 Report Share Posted September 13, 2021 On 05/02/2019 at 19:41, RyanB said: Anyone know where I can acquire some gloss black headlight eyebrows/eyelids for a 7.5? Found millions for the mk7 but apart from Ali express can’t find anything for the 7.5 and apparently the mk7’s won’t fit 🤔 cheers Did you ever find a solution to this, desperately looking myself... Quote Link to comment Share on other sites More sharing options...
Raiden Posted November 5, 2021 Report Share Posted November 5, 2021 Front wind screen washers are not working? Would it be a fuse or clogged up? Not sure how to proceed Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
gregozedobe Posted November 6, 2021 Report Share Posted November 6, 2021 19 hours ago, Raiden said: Front wind screen washers are not working? Would it be a fuse or clogged up? Not sure how to proceed If you can hear the washer motor running I'd look for clogged jets (more common if you fill with non-VW fluid) or kinked/dislodged pipes. If the motor is not running then investigate electrical issues (or dead washer motor). Raiden 1 Quote Link to comment Share on other sites More sharing options...
Jc7.5r Posted November 11, 2021 Report Share Posted November 11, 2021 On 12/08/2021 at 09:23, ChazR said: Hi mate I went for a full Hertz setup in mine and it sounds awesome. I have a 5 channel Mpower amp powering the 4 front speakers and a 12" Sub in the boot. Much better than Dynaudio now! Cost about £1200 all in obviously you don't have to go that far! A lot of people do the Helix sub install which goes in place of the spare wheel and that is sufficient for most people and costs about £400-600 depending on where you get it from and install it. I have the full Dynaudio package. In all honestly it sounds OK, but is miles behind the Burmester in the Merc. The setup seems to cause a lot of rattles in the doors and the surrounding plastics which is a huge annoyance. Not to mention if you turn the boot subwoofer anything above 3 it causes the windows to shake and rattle which is just embarrassing. All in all I dont think the audio setup is great by any means but it is slightly better than the boggo setup - a custom setup with proper sound deadening would be a better choice and will defo be cheaper too. Quote Link to comment Share on other sites More sharing options...
NRW Posted April 6, 2022 Report Share Posted April 6, 2022 We Connect Renewal Invitation? I’m disinclined to renew. I Usually use CarPlay / Google Maps or Waze. £100odd better spent on other items IMO. Are there things to miss. My R has Just turned 3yo. Any comments welcome. Ta Quote Link to comment Share on other sites More sharing options...
Zero1 Posted April 12, 2022 Report Share Posted April 12, 2022 Anyone had a rear door speaker replaced due to leaking recently and what was the cost? Was it from the dealership? Also, I'm in warranty but I note the warranty doesn't cover seals. I guess I'm footing the bill for this one as technically the seal has failed Also regarding warranty claims on approved used cars, would I have to go back to the dealership I bought it from? It's a different franchise to my local one Quote Link to comment Share on other sites More sharing options...
Mrbxx Posted June 2, 2022 Report Share Posted June 2, 2022 Quick question, I have my EPC light coming on a limiting the car to 4000rpm, the temp rises above 90c at the same time this happens. As soon as I switch the car off and on again everything is ok for a while. VCDS faults codes are relating to cooling / coolant flow insufficient. Do you think thermostat or coolant temp sensor is faulty and would this put the car into limp mode? Thank you Quote Link to comment Share on other sites More sharing options...
gregozedobe Posted June 2, 2022 Report Share Posted June 2, 2022 28 minutes ago, Mrbxx said: Quick question, I have my EPC light coming on a limiting the car to 4000rpm, the temp rises above 90c at the same time this happens. As soon as I switch the car off and on again everything is ok for a while. VCDS faults codes are relating to cooling / coolant flow insufficient. Do you think thermostat or coolant temp sensor is faulty and would this put the car into limp mode? Thank you Could be a failing waterpump. Does the engine smell hotter than usual when this happens ? I assume you are keeping a very close eye on the coolant level, as coolant leaks are common with these engines. Quote Link to comment Share on other sites More sharing options...
Mrbxx Posted June 2, 2022 Report Share Posted June 2, 2022 No smells to my knowledge and when i turn the car off and on again it runs as normal at 90c. Would a faulty water pump or coolant leak put the car into limp mode? I suppose if that is the only code I'm getting (P00B7) on vcds it has to be related to coolant flow/water pump/ thermostat I'm going to drive it with vcds connected and check live temperatures when the car goes into fault. See what readings the coolant temp sensor is giving Thanks for your help gregozedobe 1 Quote Link to comment Share on other sites More sharing options...
gregozedobe Posted June 3, 2022 Report Share Posted June 3, 2022 9 hours ago, Mrbxx said: No smells to my knowledge and when i turn the car off and on again it runs as normal at 90c. Would a faulty water pump or coolant leak put the car into limp mode? I suppose if that is the only code I'm getting (P00B7) on vcds it has to be related to coolant flow/water pump/ thermostat I'm going to drive it with vcds connected and check live temperatures when the car goes into fault. See what readings the coolant temp sensor is giving Thanks for your help Unless you are losing enough coolant that the water pump is running out of coolant or the coolant level is too low in the reservoir or there is a big enough leak that the coolant is running with a low pressure I wouldn't expect a coolant leak to throw an error code or cause limp ode. Quote Link to comment Share on other sites More sharing options...
Mrbxx Posted June 4, 2022 Report Share Posted June 4, 2022 I am also getting the below readings on vcds IDE00025 Coolant temperature 13 °C IDE00187 Coolant temperature at engine start 12.7 °C IDE00192 Coolant temperature at radiator outlet: actual value 14.0 °C IDE00193 Coolant temperature at engine outlet: specified value 13.5 °C IDE00194 Coolant temperature at radiator output: specified value -48.0 °C IDE00195 Coolant temperature difference between engine and radiator 0.0 °C IDE03377 Coolant temp at radiator output: unconditioned voltage 3.787 V IDE06396 Coolant temperature at engine outlet: unconditioned voltage 3.811 V Thank you Quote Link to comment Share on other sites More sharing options...
gregozedobe Posted June 5, 2022 Report Share Posted June 5, 2022 On 04/06/2022 at 21:54, Mrbxx said: I am also getting the below readings on vcds IDE00025 Coolant temperature 13 °C IDE00187 Coolant temperature at engine start 12.7 °C IDE00192 Coolant temperature at radiator outlet: actual value 14.0 °C IDE00193 Coolant temperature at engine outlet: specified value 13.5 °C IDE00194 Coolant temperature at radiator output: specified value -48.0 °C IDE00195 Coolant temperature difference between engine and radiator 0.0 °C IDE03377 Coolant temp at radiator output: unconditioned voltage 3.787 V IDE06396 Coolant temperature at engine outlet: unconditioned voltage 3.811 V Thank you Is that immediately after starting a cold engine ? (I hope so) What is it after the engine has been running for at least 10 minutes ? Quote Link to comment Share on other sites More sharing options...
Mrbxx Posted June 8, 2022 Report Share Posted June 8, 2022 Hi Greg, That was from a cold engine yes, below are the readings when up to operating temperature IDE00025 Coolant temperature 97 °C IDE00187 Coolant temperature at engine start 54.0 °C IDE00192 Coolant temperature at radiator outlet: actual value 20.5 °C IDE00193 Coolant temperature at engine outlet: specified value 97.5 °C IDE00194 Coolant temperature at radiator output: specified value -48.0 °C IDE00195 Coolant temperature difference between engine and radiator 79.5 °C IDE03377 Coolant temp at radiator output: unconditioned voltage 3.521 V IDE06396 Coolant temperature at engine outlet: unconditioned voltage 0.840 V Went into limp mode again on the way home last night, temperature gauge went to 100c then down to 80c and back to 90c. Restarted the car and all good! Is it worth replacing the radiator sensor before anything else? Quote Link to comment Share on other sites More sharing options...
gregozedobe Posted June 9, 2022 Report Share Posted June 9, 2022 On 08/06/2022 at 17:03, Mrbxx said: Hi Greg, That was from a cold engine yes, below are the readings when up to operating temperature IDE00025 Coolant temperature 97 °C IDE00187 Coolant temperature at engine start 54.0 °C IDE00192 Coolant temperature at radiator outlet: actual value 20.5 °C IDE00193 Coolant temperature at engine outlet: specified value 97.5 °C IDE00194 Coolant temperature at radiator output: specified value -48.0 °C IDE00195 Coolant temperature difference between engine and radiator 79.5 °C IDE03377 Coolant temp at radiator output: unconditioned voltage 3.521 V IDE06396 Coolant temperature at engine outlet: unconditioned voltage 0.840 V Went into limp mode again on the way home last night, temperature gauge went to 100c then down to 80c and back to 90c. Restarted the car and all good! Is it worth replacing the radiator sensor before anything else? Something is certainly wrong with this reading: Coolant temperature at radiator output: specified value -48.0 °C I'm not one for just replacing parts in the hope of fixing a problem, but it might be worth replacing the sensor that gave you that reading (but check all wiring & connectors first). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.